Delphix Products

Expand all | Collapse all

Two network interfaces for the same target

Jump to Best Answer
  • 1.  Two network interfaces for the same target

    Posted 06-25-2015 02:13:00 PM
    Hi all,

    as you can see in the following figure,

    the customer would like to use two different interfaces each linked to a different network segment: one dedicated to NFS protocol and one for all other protocols.But I know that if I add an environment to the Delphix Engine, I have to provide one and only one IP. So I think that is impossible to use two different subnets.
    But I ask you, guys before I'll answer to customer.

    Thank you.

    #Tip


  • 2.  RE: Two network interfaces for the same target
    Best Answer

    Posted 06-26-2015 05:02:00 PM
    Gianpiero,

    This is a question we are frequently asked, as this is a pretty common requirement. We do support multiple subnets on a target. The network that will be used for NFS is determined by the host address given when adding the environment (this network will also carry SSH traffic between Delphix and the target). So, configure the environment using the NFS VLAN address.

    When we discover the environment, we will pick up the listeners on the other network(s), and we will register VDBs to those listeners, making them available on that network. 

    For the "Delphix VLAN" in this diagram, you would need to have a listener on this network in order for Delphix to use it for JDBC connectivity to the VDB. 

    Please let me know if you have any further questions.

    Thanks,

    Michael


  • 3.  RE: Two network interfaces for the same target

    Posted 06-27-2015 11:09:00 AM
    So we can route SSH and NFS packets in the azure lines (NFS Vlan) and we can route SQL*NET packets into the red lines (Delphix VLAN).

    Thak you for your time Michael.