My initial installation failed, didn't complete, or didn't start. Help?

  • 0
  • 1
  • Question
  • Updated 4 years ago
  • Answered
Photo of Adam Bowen

Adam Bowen, Official Rep

  • 21,126 Points 20k badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of Adam Bowen

Adam Bowen, Official Rep

  • 21,126 Points 20k badge 2x thumb
Official Response
  1. Validate all three VM's have an IP address and are on the same network
  2. Reboot the Linux Source and Linux Target
    1. Installation validation happens automatically on boot.
    2. Landshark will detect what installation steps remain to be completed, and will pick up from there.
  3. If, for some reason, a dSource is added but then it fails and goes to a disabled state, delete the dSource and go to step 2.