Red and yellow labels near dSource and vDBs

  • 0
  • 1
  • Question
  • Updated 5 months ago
  • Answered
I see red and yellow color labels in the left of my dSource and vDBs. What does that indicate?
Photo of Swathy Sukumar

Swathy Sukumar

  • 866 Points 500 badge 2x thumb

Posted 5 months ago

  • 0
  • 1
Photo of Neal Stack

Neal Stack, Official Rep

  • 2,512 Points 2k badge 2x thumb
Official Response
Hello,

Red means there was a critical fault. Yellow means there was a warning.

There are a few ways to see what is causing the fault:
  • In the top right hand corner of the GUI, click "Faults". Page through to the dSource/VDB with the fault.
  • In Delphix 5.2 or higher, you may click on the VDB itself. Then click the "Status" tab.
  • In Delphix 5.2 or higher, you may go under the System -> Faults menu.
  • You can also look under System -> Events in 5.2 (or System -> Event Viewer releases older than 5.2).
Thanks,
  Neal