Delphix Products

Expand all | Collapse all

My initial installation failed, didn't complete, or didn't start. Help?

Jump to Best Answer
  • 1.  My initial installation failed, didn't complete, or didn't start. Help?

    Posted 12-06-2014 02:41:00 PM


  • 2.  RE: My initial installation failed, didn't complete, or didn't start. Help?
    Best Answer

    Posted 12-06-2014 02:42:00 PM
    1. Validate all three VM's have an IP address and are on the same network
    2. Reboot the Linux Source and Linux Target
      1. Installation validation happens automatically on boot.
      2. Landshark will detect what installation steps remain to be completed, and will pick up from there.
    3. If, for some reason, a dSource is added but then it fails and goes to a disabled state, delete the dSource and go to step 2.