Delphix Products

 View Only
  • 1.  getting error when try to connect the continuous engine in dct

    Posted 05-14-2024 02:26:00 AM

    Hi Everyone 

    Getting error when i try to connect the continuous engine in dct. i was try to connect this with username and password for this we had to add any certification in engine or in dct. We have private ip only for engine. 

    Thanks 



    ------------------------------
    Abhinandan Sharma
    Engineer
    Unisys Corporation
    ------------------------------


  • 2.  RE: getting error when try to connect the continuous engine in dct

    Posted 05-14-2024 02:39:00 AM

    Hello,

    >  i was try to connect this with username and password for this we had to add any certification in engine or in dct

    DCT connects to engines over HTTPs, and thus normally requires TLS certificates to be configured on the engine. If you are using private IP addresses only, and have not configured TLS certificates on the engine, you may select the "Insecure SSL" and "Unsafe hostname check" options when connecting an engine, which will allow these engines to be registered at the cost of preventing DCT from detecting man-in-the-middle attacks.

    > Getting error when i try to connect the continuous engine in dct

    A connection time out errors usuall indicates that a firewall is preventing DCT from connecting to the engine over HTTPs (TCP on port 443). Do you have a firewall between the server or cluster hosting DCT and the engines you are trying to connect?


    Eyal



    ------------------------------
    Eyal Kaspi
    Principal Engineer
    Delphix
    ------------------------------



  • 3.  RE: getting error when try to connect the continuous engine in dct

    Posted 05-14-2024 04:37:00 AM

    Hi Eyal
    I tried with "Insecure SSL" and "Unsafe hostname check" and the Delphix engine port are opened for 443 source and destination any.




    ------------------------------
    Abhinandan Sharma
    Engineer
    Unisys Corporation
    ------------------------------



  • 4.  RE: getting error when try to connect the continuous engine in dct

    Posted 05-14-2024 04:47:00 AM

    Hi,

    Please open a support ticket so that we can have a support engineer investigate what is causing this problem.

    Eyal



    ------------------------------
    Eyal Kaspi
    Principal Engineer
    Delphix
    ------------------------------